Skip to product information

Status Teflon Heat Strip

  • In stock, ready to ship
Regular price $9.95 AUD
Sale price $9.95 AUD Regular price
Save 0
Tax included.

Status Teflon heat strip

Replacement Status Teflon heat strip for your status vacuum sealer, these are suitable for the Status Minivac, Status HV500, Status FV500 and the Status Provac 360. Select the correct one for your vacuum sealer. These Status Teflon heat strip can be cut to length so as long as the width is the same they will fit many other models of vacuum sealers.

Status Teflon heat strip sizes

  • Status Minivac heat strip is 10 mm wide and 32 cm long.
  • Status HV100 heat strip is 12 mm wide and 32 cm long.
  • Status HV500 heat strip is 12 mm wide and 32 cm long.
  • Status FV500 heat strip is 12 mm wide and 36 cm long.
  • Status SV2000 heat strip is 10 mm wide and 35 cm long.
  • Status Solid 300 heat strip is 20 mm wide and 35 cm long.
  • Status Provac heat strip is 20 mm wide and 42 cm long.


Installing the Status Teflon heat strip

  • Peel the old heat strip off.
  • Clean the area very well and do not disturb the wire.
  • Cut the new one to size.
  • Peel the backing off the new one and stick it in place.
  • Run a finger over it as you stick it down to ensure it is stuck and there are no bumps or ripples in it.


This Status Teflon heat strip

Can easily fit a wide range of vacuum sealers on the market. If you are unsure please contact us with the model, the width of the strip and the length. It is important to have this strip on your vacuum sealer as if it is not, you will probably melt through the bag. It must also be in good condition or else it may affect certain parts of the seal.

To check the Status Teflon heat strip.

Firstly please use a good quality roll film as poor quality roll film will not seal properly any way. Do a seal on the end of the roll film. Then hold it up to the light. The seal should be clear, the same width all the way and no imperfections in it. If there is a fault in the seal then do another seal beside the first one. If the imperfection is in the same spot, then the Status Teflon heat strip is probably damaged in that spot. It will need replacing. Use genuine Status Teflon heat strip.

For more information on replacing your Teflon heat strip. Click here 
  • Estimated delivery for standard post for NSW, ACT, VIC, QLD: Jul 26 - Jul 30
  • Allow extra for SA, NT, WA All orders shipped with Australia post. Express post is quicker but not overnight

Recently viewed products