Lava Teflon Heat Strip

Lava Teflon heat strip

Replacement Lava Teflon heat strip for your Lava vacuum sealer, these are suitable for the Lava V.100, Lava V.200, all Lava V.300, Lava V.350, Lava V.400, Lava V.500. Select the correct one for your vacuum sealer. These Lava Teflon heat strip can be cut to length so as long as the width is the same they will fit many other models of vacuum sealers.

Status Teflon heat strip sizes

• Lava V.100, V.200, V.300 models heat strip is 10 mm wide and 32 cm long.
• Lava V.350 heat strip is 12 mm wide and 32 cm long.
• Lava V.400 heat strip is 12 mm wide and 32 cm long.
• Lava V.500 heat strip is 12 mm wide and 36 cm long.

Installing the Lava Teflon heat strip

• Peel the old heat strip off.
• Clean the area very well and do not disturb the wire.
• Cut the new one to size.
• Peel the backing off the new one and stick it in place.
• Run a finger over it as you stick it down to ensure it is stuck and there are no bumps or ripples in it.

This Lava Teflon heat strip

Can easily fit a wide range of vacuum sealers on the market. If you are unsure please contact us with the model, the width of the strip and the length. It is important to have this strip on your vacuum sealer as if it is not, you will probably melt through the bag. It must also be in good condition or else it may affect certain parts of the seal.

To check the Lava Teflon heat strip.

Firstly please use a good quality roll film as poor quality roll film will not seal properly any way. Do a seal on the end of the roll film. Then hold it up to the light. The seal should be clear, the same width all the way and no imperfections in it. If there is a fault in the seal then do another seal beside the first one. If the imperfection is in the same spot, then the Lava Teflon heat strip is probably damaged in that spot. It will need replacing. Use genuine Lava Teflon heat strip.