Status FV500 Heat Strip

  • $9.95
    Unit price per 
Tax included. Shipping calculated at checkout.


Status FV500 Heat Strip

Replacement teflon FV500 heat strip for your vacuum sealer, this one is suitable for the Status FV500 Family Vac

This Teflon FV500 Heat Strip is 12mm wide and 36cm long. It can be cut to the length that you rquire.

It is suitable for Status FV500 Family Vac

Installing The Teflon FV500 Heat Strip

  • Peel the old heat strip off
  • Clean the area very well and do not disturb the wire
  • Cut the new one to sizes
  • peel the backing off the new one and stick it in place
  • Run a finger over it as you stick it down to ensure it is stuck and there are no bumps or ripples in it
This tefflon FV500 heat strip

can easily fit a wide range of vacuum sealers on the market. If you are unsure please contact us with the the model, the width of the of the strip and the length. It is important to have this strip on your vacuum sealer as if it is not you will probably melt through the bag. It must also be in good condition or else it may effect certain parts of the seal.

To check the Teflon FV500 heat strip seal.

Firstly please use a good quality roll film as poor quality roll film will not seal properly any way. Do a seal on the end of the roll film. Then hold it up to the light. The seal should be clear, the same width all the way and no imperfections in it. If there is a fault in the seal then do another seal beside the first one. If the imperfection is in the same spot, then the teflon strip is probably damaged in that spot. It will need replaceing.

Food Vacuum Sealers Australia products are also supplied by BJ Enterprises and Marketing in Australia and C & M Marketing in New Zealand


We Also Recommend